Cross-band line
The Cross-band Line control allows you to draw a line through several bands. This can be useful if it is required to visually emphasize a section consisting of multiple band areas. In other aspects, it is similar to a regular Line.
Another cross-band control available is the Cross-band Box.
In the Property Grid, the cross-band line control's properties are divided into the following groups.
| Property |
Description |
| ForeColor
|
Specifies the color of the control's line. This option is also available on the ribbon |
| Line Style
|
You can select a solid (by default), dashed, dotted or mixed style for the line. |
| Property |
Description |
| Anchor Horizontally |
Specifies the horizontal anchoring style of the control, so that after page rendering it stays attached to the left control, right control, or both. |
| Anchor Vertically |
Specifies the vertical anchoring style of the control, so that after page rendering it stays attached to the top control, bottom control, or both. |
| Visible |
Specifies whether the control should be visible in Print Preview. |
| Property |
Description |
| Tag |
This property allows you to add some additional information to the control; for example its id, by which it then can be accessible via scripts. |
| Property |
Description |
| End Band
|
Determines a band, in which the control finishes drawing. |
| End Point
|
Determines the end point (from a band's upper left corner) where the control finishes drawing. |
| Snap Line Margin
|
Specifies the margin (in report measurement units), which is to be preserved around the control when it is aligned using Snap Lines, or when other controls are aligned next to it. |
| Start Band
|
Determines a band, in which the control starts drawing. |
| Start Point
|
Determines the starting point (from a band's upper left corner) where the control starts drawing. |
| Width |
Specifies the line's width in report measurement units. |
